New garage door installation and replacement in Perth
Measured on site, supplied to fit, the old door taken down and the new roller, sectional or tilt door installed with its opener set up.
- Roller, sectional and tilt doors
- Written quote after measuring
- Perth's north-east and beyond
Measured before it's quoted
Quick Answer
Garage door replacement in Perth starts with a measure, not a brochure price. We check the opening, headroom, side room and the frame, talk through roller, sectional and tilt options, and give you a written quote. On installation day the old door comes out, the new one goes in and is balanced to its weight, and the opener is fitted and programmed before we hand it over.
Choosing and fitting a new garage door
A new door has to suit the garage as much as the house. Sectional doors need headroom for their overhead tracks and give a snug seal and a clean face. Roller doors need room above the opening for the drum but almost nothing along the ceiling, which suits low or cluttered garages. Tilt doors swing outward, so they need clear driveway in front, and they suit some openings the other types can't. We talk through those trade-offs on site.
Measuring decides most of it. We take the opening width and height, the headroom from the top of the opening to the ceiling, the side room on each side, and the depth back into the garage. We also look at the frame, the floor level and where the power point sits for a motor. Getting those right is what stops a new door rubbing, leaving gaps or straining its opener a few months after installation.
On the day we protect the driveway and the area around the opening, let the old door's spring tension down safely, and take it away. The new door is fitted, its springs set to its weight, and its travel checked along the full run. The opener goes on last, with limits, force and safety reverse set and your remotes coded. Before we leave, we show you how the manual release works.
Signs it's time to call us
What the job covers
- An on-site measure of opening, headroom, side room and depth
- Advice on roller, sectional and tilt options for your garage
- A written quote covering the door, opener and installation
- Safe removal of the old door, with its springs let down first
- New door fitted, levelled and its springs set to its weight
- Opener installed, limits and safety reverse set, remotes coded
- Weather seals fitted along the bottom and sides
- A walk-through of the manual release and simple upkeep
From your call to a door that runs right
Book a measure
Tell us roughly what you have now and what you're considering, and we'll arrange a time to look at the opening.
Measure and options
We measure, check the frame and power, and talk through door types, finishes and insulation.
Written quote
One document covering the door, the opener and the installation, so you can compare like with like.
Remove, install, hand over
Old door out, new door in, opener set up and tested, and a run-through with you before we go.
How WestPro handles the job
We repair doors too
Because repairs are most of what we do, we'll tell you plainly if your current door can be saved instead.
Quoted after measuring
No guesswork from a photo. The price follows a proper measure of your opening and headroom.
Local measure and install
From Ballajura we measure and fit across Morley, Wanneroo, Ellenbrook and the surrounding suburbs, with springs and opener tuned to the new door's weight.
Related services and price guides
Where we work
We work out of Ballajura, through Perth's north-east and northern suburbs, including these suburbs:
- Perth
- Ballajura
- Malaga
- Noranda
- Beechboro
- Bennett Springs
- Kiara
- Lockridge
- Eden Hill
- Morley
- Dianella
Suburb not listed? See the full coverage list — homes further across Perth can be booked too.
Request QuoteFrequently Asked Questions
A common single door is about 2,400 mm wide and a common double about 4,800 mm, both usually about 2,100 mm high. Wider singles and doubles up to around 6,000 mm are also made, and sizes vary by maker and door type. We measure your opening and the room around it before quoting, because the usable opening can be smaller than the door.
Fitting a standard door usually takes a few hours once it is on site, and longer if the opening needs work or an opener is going in. The longer wait is often the door itself, since many are made to order. We give you the expected timing with the written quote.
Yes. A new sectional door comes with its own tracks, and a new roller door with its own side guides, as part of the door's hardware. The written quote lists what is included, and says whether taking away the old door is part of the price.
It depends on the door type, the size of the opening, the material and finish, insulation, and whether a motor is included. A single roller door and a double insulated sectional sit at very different points. We measure and quote in writing, and the new door cost guide explains each factor so you can compare quotes properly.
Start from what the garage needs: the door type that suits your headroom, whether you want insulation, and whether the existing motor can stay. Then allow for the opener and the installation, which are separate parts of the job. Our written quote lists each one on its own line so nothing turns up later.
Yes. The figure covers supplying the door, taking the old one down, installing the new door and setting it up, plus the opener if you're having one. If anything outside that is needed, such as building work on the opening, we point it out before you agree.
Repair is almost always cheaper when the panels or curtain are sound and the fault is in springs, cables, rollers or the motor. Replacement starts to make sense when panels are badly damaged or rusted, parts for an older door can't be found, or you're paying for repeat repairs. We'll give you an honest view either way.
Sometimes. If the opener suits the new door's type and weight and is in good order, we can refit and re-set it. Older units, or a switch from a tilt door to a sectional, usually call for a new motor. We check it during the measure and include our recommendation in the quote.
Get a quote
Book Door Replacement & Installation in Perth
Tell us what the door is doing and which suburb you're in. We'll reply with a time window, and once we've seen the door you get a written price before any work starts. Or call and talk it through.
- (08) 5550 0311
- Ballajura WA
- Open 24 hours, 7 days
Ask for a written quote
Prefer to call? (08) 5550 0311Door playing up?
Tell us what it's doing.
Describe the noise, the gap or the blinking light. We book a time window, ring when we're heading over, and price the fix before any work begins, anywhere across Perth's north-east and northern suburbs.